| 螺杆式启闭机的操作与维护 |
| 添加时间：2017/9/15 16:42:06 浏览次数： |
| 螺杆启闭机的正确操作和维护： 1)螺杆启闭机安装时底座地基应牢固平整，留有地脚螺丝孔的位置，启闭机到位后，找平浇灌成型。 Screw hoist proper operation and maintenance: 1) when the screw hoist installed, the base should be solid and flat, leaving the anchor screw hole position, headstock machine in place, leveling irrigation molding. 2)启闭机的丝杆必须平行于闸门研磨轨道表面，同时垂直与吊耳轴、双吊点式两个机座必须平衡，两个丝杆平行，同时垂直与吊耳轴、手摇或带电，先手摇启动上下几次，达到规范后方可带电使用，带电操作时，设有下降深度控制器，但操作人员不得擅离场地，以防因电路等故障，造成碰撞事故的发生。 2) and closed screw machine must be parallel to the ground surface and the vertical track gate, and lug shaft, double hook type two base must be in balance, two screw rods are parallel and vertical with the lug shaft, hand or charged, first hand starting up and down several times, to standardize the rear can be charged using the charged operation, has decreased, but depth controller, the operator shall not leave the site, so as to prevent circuit fault caused by collision accidents. 螺杆式启闭机的维护保养： Maintenance of screw type headstock gear: (1)本产品出厂前以加足黄油，整机验收合格。根据实用情况，3-5年整机打开大修一次。 (1) this product is filled with butter before leaving the factory, and the whole machine has been checked and accepted. According to the actual situation, 3-5 years, the whole machine open overhaul. (2)安装使用前，应作一次检查，试验运行，清理污圾，进行润滑，螺杆的螺纹段则应涂抹黄油，以防生绣。 (2) before the installation and use, should make an inspection and test operation, clean up garbage pollution, lubrication, the screw thread section should smear butter, to prevent rust. 螺杆在使用中容易产生弯曲现象，这是由于闭门时过分施加了压力的结果，应当及时卸下，将其校直，另外需在螺纹顶端核定升降高度，固定限位螺母和涂以警色标记，以谨慎操作安全运行。 The screw is easy to produce bending phenomenon in use, this is due to excessive pressure closed when the results, shall promptly remove the straightening, also approved the lifting height in the top thread, fixed spacing nut and coated with police color marker, to the safe operation of prudent operation. |
| 上一页 螺杆式启闭机安装与调试 |
| 下一页 没有了 |
Copyright © 技术支持：遨游网络