洛阳通风管道知名加工厂

清洗机操作规程

Rules of operation for cleaning machines

准备前奏

Prelude to preparation

检查管路系统有无漏气漏水的情况，如有这种情况，应通知维修人员修理。检查清洗液是否足够，如果不够，及时增加清洗液。先点动试车，然后空运转2-3分钟，检查传动系统（电动机、联轴节、减速器）和运输带的运动是否平稳，确认一切正常后，方可进行生产。开启浮油排除装置（不带浮油排除装置除外）开始浮油排除，因此时水泵尚开启，水面平静，排油效果最好，待浮油基本排除后停止除油，排油污多克利用午休时间进行。

Check whether there is leakage or not in the pipeline system. If this happens, the maintenance personnel should be notified to repair it. Check whether the cleaning fluid is sufficient, if not, add the cleaning fluid in time. Start with the test run, then run empty for 2-3 minutes, check whether the movement of the transmission system (motor, coupling, reducer) and the conveyor belt is stable, and confirm that everything is normal before production. Open oil slick removal device (except without oil slick removal device) to start oil slick removal, so the water pump is still open, the water surface is calm, and the oil drainage effect is the best. After the oil slick is basically removed, the oil removal will stop, and the oil pollution will be removed by noon break time.

操作事项

Operational matters

被清洗的零件要整齐地放在运输带上，不许压在滚轮上；在运输带上，被清洗的零件不能堆得过多，以免影响清洗效果。工作后，被清洗的零件不能停放在运输带上， 按停止按钮，使全机停止运行。清洗机  采用不同的方法清洗包装容器、包装材料、包装辅助物、包装件，达到预期清洁程度的机器。清洗液应定期添加水和一定比例的金属清洗剂以补充消耗，使液面保持在一定高度，如果清洗效果达不到规定的工艺要求时，应全部更换清洗液。

The parts to be cleaned should be placed neatly on the conveyor belt and not pressed on the rollers. On the conveyor belt, the parts to be cleaned should not be stacked too much to avoid affecting the cleaning effect. After work, the cleaned parts can not be parked on the conveyor belt. Press the stop button to stop the whole machine. Cleaning machine uses different methods to clean packaging containers, packaging materials, packaging aids, packaging parts, to achieve the expected cleanliness of the machine. Water and a certain proportion of metal cleaner should be added regularly to make up for consumption, so as to keep the liquid level at a certain height. If the cleaning effect can not meet the prescribed process requirements, the cleaning fluid should be replaced completely.