洛阳通风管道知名加工厂

Installation debugging

启闭机在出厂前已加足黄油，一般在使用一段时间后，要根据情况随时加油润滑。

The hoist has been filled with butter before leaving the factory. After being used for a period of time, it should be lubricated at any time according to the situation.

2、启闭机的安装方法和一般机械相同，安装前一定要检查各部零件是否良好，螺栓有无松动与其有关技术数据是否相符。启闭机支架与基础布置平面接触面积要达到90%以上，螺杆轴线要垂直于闸台上横梁水平面，并与闸板吊耳中心重合，以免受侧向力螺杆弯曲或闸门受卡损坏机件。 

2. The installation method of the hoist is the same as that of the general machine. Before installation, it is necessary to check whether the parts of each part are good, or whether the bolt is loosened or not, and whether it is consistentmumen.37ix.com.cn junranji.75ix.com pensuji.89ix.comtongbang.75ix.comfenliqi.75ix.com xuanzhuang.89ix.com  with the relevant technical data. The plane contact area of the hoist frame and the base layout should be above 90%. The axis of the screw should be perpendicular to the horizontal plane of the upper beam on the gate, and coincide with the center of the sluice, so as to avoid the bending of the side force screw or the damage of the lock. It

3、启闭机安装好后，要进行试运行，先作无载荷试验，让螺杆作二个行程，听其有无异常声音，检查是否符合技术要求。二即要作载荷试验，如果新装闸门一定要将闸门的运输和装配工艺固定件拆除，试验时注意闸门有无卡死和偏起现象，如有应先行处理再试运转，在额定载荷下，让螺杆作二个行程，观察螺杆与闸门的运行情况，有无异常现象，确认无误后，方可正式运行。在载荷运行一段时间后要进行首次保养，把机内新机件摩擦产生的金属沫，特别是螺杆、螺，母、蜗轮、蜗杆，要清洗干净，涂上润滑油，继续使用。

3, after the installation of the hoist, the test run, first without load test, let the screw two trips, listen to its abnormal sound, check whether it meets the technical requirements. Two is to make a load test. If the new gate must be removed from the transport of the gate and the fixed part of the assembly process, it should be noticed whether the gate has the phenomenon of death and deviation. If there should be a trial operation, the screw will be made two strokes under the rated load, and the operation of the screw and the gate can be observed, and there is no abnormal phenomenon. When it is confirmed, it can run formally. After the load is running for a period of time, it should be maintained for the first time, and the metal foam produced by the friction of the new machine parts in the machine, especially the screw, screw, mother, worm wheel and worm, should be cleaned, coated with lubricating oil and continued to be used.